PDA

View Full Version : Problem trying to add App Tapp


J-Man
09-22-2007, 11:07 AM
I am trying to load app Tapp on my phone. I have been following the directions on modmyiphone. I am running 1.0.2 and ran independence and got through part 2 using jailbreak. I then went to part 3 downloaded App Tapp and tried to run it. Independence is not running. When I run App Tapp I choose firmware 1.0.2 it starts to run then comes up Bootstrap failed, see Console log! (ABORT) and goes no further. My phone is telling me "Please connect to itunes". Any help would be appreciated.
Sent that out on the forum at modmyiphone. I was told that my phone was already jail broke and that I should load app tapp using ibreezy.
Took that advice and tried to load breezy. I followed the directions on the screen ;i.e. hold buttons down until told otherwise. and breezy crashes. I found other directions on this board that suggested you hold down both buttons then turn the phone off then back on again while running the breezy software. Breezy came up with an error message can't jailbreak the phone and that was as far as it got. Now what?
Every time I try any of these I have to reset my phone. getting frustrated.
Thanks for any help