iPhone 3G | iPod touch Forums - View Single Post

iPat · 01-15-2008, 05:18 PM

Ok, I'm still having tons of trouble getting my iPhone back into a jailbroken 1.1.2 state. All usefull information on this topic is greatly appreciated. Here's what happened.
I was on 1.1.2, jailbroken and enjoying my phone. I goofed up and managed to make all my icons disappear. I tried to install some launchers to get back to Customize and bring them back, with no success. I have since restored my iPhone to 1.1.2. I can downgrade my firmware to 1.1.1, see the usual error 1015, and run the windows.bat file from the dev team kit to get it out of recovery mode. This is where my new problem begins. I am in 1.1.1 but my iPhone will not activate through iTunes. I am an AT&T customer, and not unlocked, nor have I ever unlocked my iPhone. It will sync, but it just sits at the activation screen, and then finally says "Activation alert. No signal detected. Signal is required to complete activation." But the phone was just active 5 minutes ago when I was on 1.1.2 in the same physical location! Does anyone have any ideas? Do I have to downgrad the modem firmware also? Tinman? Anyone? Please help.

Firmware 1.1.1(3A109a)
Modem firmware 04.02.13_G
Windows Vista Home Prem.
iTunes 7.4.3.1
I can slide into the main springboard screen and access all the PDA stuff and iPod, but the phone is no picking up the network.

01-15-2008, 05:18 PM	#1 (permalink)
iPat Join Date: Sep 2007 Posts: 24 Thanks: 0 Thanked 0 Times in 0 Posts	Still can't get back to 1.1.2 Ok, I'm still having tons of trouble getting my iPhone back into a jailbroken 1.1.2 state. All usefull information on this topic is greatly appreciated. Here's what happened. I was on 1.1.2, jailbroken and enjoying my phone. I goofed up and managed to make all my icons disappear. I tried to install some launchers to get back to Customize and bring them back, with no success. I have since restored my iPhone to 1.1.2. I can downgrade my firmware to 1.1.1, see the usual error 1015, and run the windows.bat file from the dev team kit to get it out of recovery mode. This is where my new problem begins. I am in 1.1.1 but my iPhone will not activate through iTunes. I am an AT&T customer, and not unlocked, nor have I ever unlocked my iPhone. It will sync, but it just sits at the activation screen, and then finally says "Activation alert. No signal detected. Signal is required to complete activation." But the phone was just active 5 minutes ago when I was on 1.1.2 in the same physical location! Does anyone have any ideas? Do I have to downgrad the modem firmware also? Tinman? Anyone? Please help. Firmware 1.1.1(3A109a) Modem firmware 04.02.13_G Windows Vista Home Prem. iTunes 7.4.3.1 I can slide into the main springboard screen and access all the PDA stuff and iPod, but the phone is no picking up the network. Last edited by iPat; 01-15-2008 at 05:30 PM. Reason: Added system info.